Tire De-Rimmers » Car Tire De-Rimmer

Overview

The Eagle Car Tire Derimmer is designed to separate waste rims from waste tires. The ease of operation is the key to the popularity of this unit. All that is required of the operator is to roll the tire and wheel into the Derimmer. The tire is then clamped and held by the first cylinder while the second cylinder removes the rim. The operator then rolls the tire out of the unit and rolls the next tire and wheel into position. The cycle time is estimated at seven (7) seconds. There is no manual lifting with this unit. Simple hand controls enhance the cycle time. The estimated times for this unit are 160-200 rims per hour which equates to 1280 rims in one 8 hr. shift. Stationary and portable models are available with a choice of gas, electric and diesel power.

Additional Information

The Eagle OTR Debeader was designed to allow for all tire recyclers to pull the heavy bead sections from all radial OTR tires. With the Eagle OTR Downsizing system we are recommending the OTR’s are downsized in the following order.

Step 1. Time to pull the steel bead bundles from the OTR tires: 5-10 minutes depending on which size tire is on the machine
Step 2. Time to bagel cut the tires into two halves through the center of the tread: 15 minutes per tire
Step 3. Time to cut the tires into pie shaped sections 10-15 minutes per bagel cut halves, time will depend on how many pieces are cut to accommodate the tire shredder used in this process.